Service Strength Safety
The Mega-Beam Clamp is a low profile sliding jaw design that allows you to secure your load as close to the I-Beam as possible. The 16" model has a 3 ton rating. The two aircraft aluminum jaws are adjusted on the 3/4"-6" tip Acme threaded shaft. The spring loaded handle locks after adjustment. Aluminum construction is half the weight of steel units and has a wider gripping range.
Fastens from 2 inch to 16 inch wide I-Beam flanges up to 1" thick. Center hole is 1-1/2"
Optional Mega-Couplers can be attached to any size Beam Clamp (see photo on right). Couplers are attached to fit standard 12" truss. If you are attaching to any other size truss (such as Global Truss) it is important to note when ordering. Coupler is part # MLM1/2CS for Mill Finish Beam Clamps and # MLB1/2CS for Black Beam Clamps.
Optional Beam Clamp Jaws can be added to any size Beam Clamp to fit up to 2" thick Beam Flanges (see photo on right). Part # MBC2INCHJAWS
Dimensions: 22.5" L x 7.5T x 2.75" WCenter Hole – 1 1/2"
Case Quantities: each